--- title: "Enabling or disabling third-Party IOC feeds on a specific appliance using the CLI" slug: "enabling-or-disabling-third-party-ioc-feeds-on-a-specific-appliance-using-cli" updated: 2026-08-25T21:18:10Z published: 2026-08-25T21:18:10Z canonical: "docs.trellix.com/enabling-or-disabling-third-party-ioc-feeds-on-a-specific-appliance-using-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling third-Party IOC feeds on a specific appliance using the CLI These procedures describe how to enable or disable a Central Management System appliance to receive indicators (IOC) from a third-party feed and distribute them to a specific managed Network Security appliance. ### Note A Central Management System appliance cannot distribute indicators of compromise (IOCs) to managed SmartVision Edition sensors. You can verify that this feature is disabled when you log in to the managed Network Security appliance. To enable a third-party feed for a specific managed Network Security appliance: 1. Log in to the Central Management System CLI. 2. Enable CLI configuration mode. ``` cm-hostname > enable cm-hostname # configure terminal ``` 3. Enable IOCs from a third-party feed for a managed Network Security appliance. ``` cm-hostname (config) # custom content enable on lms ``` where `applianceID` is the Network Security appliance record name. 4. Verify the status of IOC customizations. ``` cm-hostname (config) # show custom content enable status CMS status        CM-1 : enabled LMS status        B9-vNX2500-1 : enabled ``` 5. Save your changes. ``` cm-hostname (config) # write memory ``` To disable a third-party feed for a specific managed Network Security appliance: 1. Log in to the Central Management System CLI. 2. Enable CLI configuration mode. ``` cm-hostname > enable cm-hostname # configure terminal ``` 3. Disable IOCs from a third-party feed for a specific managed Network Security appliance. ``` cm-hostname (config) # no custom content enable on lms ``` where `applianceID` is the Network Security appliance record name. 4. Save your changes. ``` cm-hostname (config) # write memory ``` 5. Log in to the CLI on the managed Network Security appliance. 6. Enable CLI configuration mode. ``` nx-hostname > enable nx-hostname # configure terminal ``` 7. Verify the status of third-party IOC feeds. ``` nx-hostname (config) # show custom content enable status Custom content : disabled ``` :