--- title: "Enabling or disabling third-party IOC feeds on all appliances using the CLI" slug: "enabling-or-disabling-third-party-ioc-feeds-on-all-appliances-using-the-cli-2" updated: 2026-08-25T21:18:25Z published: 2026-08-25T21:18:25Z canonical: "docs.trellix.com/enabling-or-disabling-third-party-ioc-feeds-on-all-appliances-using-the-cli-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling third-party IOC feeds on all appliances using the CLI These procedures describe how to enable or disable a Central Management System appliance to receive indicators (IOC) from a third-party feed and distribute them to all managed Network Security appliances. ### Note A Central Management System appliance cannot distribute indicators of compromise (IOCs) to managed SmartVision Edition sensors. To enable a third-party feed for all managed Network Security appliances: 1. Log in to the Central Management System CLI. 2. Enable CLI configuration mode. ``` cm-hostname > enable cm-hostname # configure terminal ``` 3. Enable IOCs from a third-party feed for all managed Network Security appliances. ``` cm-hostname (config) # custom content enable ``` 4. Verify the status of third-party IOC feeds. ``` cm-hostname (config) # show custom content enable status CMS status        CM-1 : enabled LMS status        B9-vNX2500-1 : enabled        B9-vNX6500-1 : enabled        Bolt : enabled        SystemVX12500-1 : enabled        SystemVX12500-2 : enabled ``` 5. Save your changes. ``` cm-hostname (config) # write memory ``` To disable a third-party feed for all managed Network Security appliances: 1. Log in to the Central Management System CLI. 2. Enable CLI configuration mode. ``` cm-hostname > enable cm-hostname # configure terminal ``` 3. Disable IOCs from all third-party feeds on the CM. ``` cm-hostname (config) # no custom content enable ``` 4. Verify the status of IOC customizations. ``` cm-hostname (config) # show custom content enable status CMS status        CM-1 : disabled LMS status        B9-vNX2500-1 : enabled        B9-vNX6500-1 : enabled        Bolt : enabled        SystemVX12500-1 : enabled        SystemVX12500-2 : enabled ``` 5. Save your changes. ``` cm-hostname (config) # write memory ``` :