Use the CLI commands to globally enable or disable the Trellix Riskware rules on the appliance.
![]() | Riskware detection for Trellix Riskware rules are enabled by default. |
Go to CLI configuration mode.
hostname > enable hostname # configure terminal
Enable the Trellix Riskware rules on the appliance.
hostname (config) # analysis riskware policy fe-rules enablehostname (config) # write memorySave your changes.
Go to CLI configuration mode.
hostname > enable hostname # configure terminal
Disable Trellix riskware rules on the appliance.
The following message is displayed:
hostname (config) # no analysis riskware policy fe-rules enable% The rules are now disabled.Trellix recommends re-enabling these rules for security reasons.Save your changes.
hostname (config) # write memory
.png?sv=2026-02-06&spr=https&st=2026-11-20T03%3A25%3A19Z&se=2026-11-20T03%3A36%3A19Z&sr=c&sp=r&sig=CcH56Zi12kJVDD6lJLduTFjwEX%2FQna7Jbq1clOVeUPE%3D)