--- title: "Enabling SmartVision using the CLI" slug: "enabling-smartvision-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:05Z published: 2026-09-02T17:27:05Z canonical: "docs.trellix.com/enabling-smartvision-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling SmartVision using the CLI Follow these steps to enable SmartVision. ### Important Before you deploy a SmartVision appliance to a production environment, make sure that the average events per second (EPS) measured on the appliance does not exceed the recommended maximum EPS. See [Checking the average EPS using the CLI](/docs/checking-the-average-eps-using-the-cli). ### Prerequisites - Admin access to the SmartVision appliance. - The appliance is a SmartVision Edition appliance or a SmartVision-capable Network Security sensor or integrated appliance. See the following topics: - [Supported appliances](/docs/supported-appliances) - [Requirements](/docs/requirements-5) - [Limitations](/docs/limitations-4) To enable : 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Enable SmartVision capabilities. ``` hostname (config) # smartvision enable Enabling SmartVision. ``` 3. Verify your configuration change. ``` hostname (config) # show smartvision status SmartVision State        Detection                      : yes        .        .        . ``` ``` hostname (config) # show smartvision config SmartVision Config        Detection Enabled             : yes        .        .        . ``` 4. Save your changes. ``` hostname (config) #  write memory ``` :