Exporting an existing token from a Central Management System peer using the CLI

Use the CLI commands to export an existing authentication token from a Central Management System peer. Use this procedure when you want to use an existing token with another Central Management System peer but do not want to generate a new token. When a token is exported, it is displayed. You can copy the existing token and send it to the administrator of a Central Management System peer.

To export an existing authentication token with a Central Management System peer:

Go to CLI configuration mode.
```
CMS1 > enable
CMS1 # configure terminal
```

Export an existing token. Partial output of the existing token is displayed.

CMS1 (config) # cms peer-service auth-token export
AUTH-TOKEN = "PD94bWwg.........."
AUTH-TOKEN CHECKSUM = "234b19a369887ef5b0bbfd269c477704"
.
.
.

Copy all the characters of the existing token within the quotes, but do not copy the quotes, from the exported auth-token.
Paste the exported token to an out-of-band mechanism (for example, a signed email).
Send the exported token to the administrator of the CM peer.