--- title: "fmps scan configure subdirectories" slug: "fmps-scan-configure-subdirectories" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:22:54Z published: 2026-08-04T17:22:54Z canonical: "docs.trellix.com/fmps-scan-configure-subdirectories" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # fmps scan configure subdirectories To specify which subdirectory a configured scan should check, use the **fmps scan configure subdirectories** command in configuration mode. > [!NOTE] > Note > > You can use this command only on scans that are in the "configured" state. You cannot configure active, paused, aborted, completed, or scheduled scans. This command allows you to limit the scope of a scan by specifying that it should check only the specified subdirectory. For more information, see the File Protect User Guide. ### Syntax `[no] fmps scan configure<scanID>subdirectories<subdirectory>` ### Parameters `no` Removes the configured subdirectory. `scanID` The numeric identifier for the scan. `subdirectories` The subdirectory to scan. ### Example The following example specifies that scan 2 should check only the Hardware subdirectory. ``` hostname (configure) # fmps scan configure 2 subdirectories Hardware ``` ### User role Operator or Admin role ### Supported appliances Command introduced in Release 7.5.0 for File Protect appliances.