Inside the box

Every fail-open kit consists of a similar set of components. Although the type of cables and the switch vary from one model to another, the list of items in the kit itself remains the same. The table below provides you the list of items.

Qty	Item	Description
1	Fail-Open switch module	10/100/1000 Copper fail-open module, or 1G 850 nm Fiber (62.5 µm) fail-open module, or 1G 1310 nm Fiber (8.5 µm) fail-open module, or 10G 850 nm Fiber (62.5 µm) fail-open module, or 10G 1310 nm Fiber (8.5 µm) fail-open module
2	Power supplies and cords for the host system	One power supply acts as the primary and the other as the redundant power supply in case of a failure.
4	Copper: 3m RJ-45 to RJ-45 cable Fiber: 3m LC-LC	Connects the fail-open switch to network devices and the Sensor Note For a fiber fail-open kit, these cables will either be single mode or multi-mode cables depending on the requirements provided at the time of purchase.
1	RS232 RJ-11 programming cable	Connects the fail-open switch to a computer to access the switch CLI that is used to configure switch parameters

Note
The Active Fail-Open switch chassis is not shipped with the box. You have to purchase a 1RU host hardware to plug in up to four fail-open switches in a standard rack.