Inspect traffic using VMware applications

Prev Next

Before you begin

Make sure you have VMware vShield Manager 5.0 or later installed with administrator access permissions for yourself. You also need to install vShield App on all your ESX servers.

Note

This section is relevant only if you plan to use VMware vCenter and vSphere for inspecting VM traffic and quarantining VMs.

The Manager can integrate with VMware vShield to quarantine an attacking VM. You must define a specific Security Group that has access rules that block all traffic. So, when a Manager includes a VM in this Security Group, the vShield App blocks all traffic from this VM.

Task

  1. Log on to vShield Manager using a browser (https://<vShield Manager IP address>).
  2. Select Datacenters → <datacenter_name> → General → Grouping.
  3. Select Add → Security Group to create a group called TrellixQuarantine with the entire datacenter as the scope.

    Note

    The name of this Security Group must be exactly named as TrellixQuarantine and this is case-sensitive.

  4. Select Next → Finish.
    Since the scope of this Security Group is the entire datacenter, you need not add group members.
  5. From the vShield Manager, select the ESX hosts to be protected, and install the vShield App by clicking Install.
  6. Provide the IP address details and complete the vShield App installation.

    Tip

    Trellix recommends that you install vShield App on all the ESX servers so that a VM continues to be quarantined even if it is moved to a different ESX server in the datacenter.

  7. In the vShield Manager, select Datacenters → <datacenter_name> → App Firewall → L3 → Inside TrellixQuarantine → Add → Add to top
    The Add L3 Rule - IP protocols window is displayed.
  8. Specify the required information in the relevant fields.
    Option definitions
    Option Definition
    Source Click the text box and select TrellixQuarantine (datacenter_name).
    Source boundary Select Inside.
    Destination Specify the destination or leave it blank, which is equivalent to any.
    Type of traffic Leave it blank, which is equivalent to any.
    Action Select Block.
    Logging Select log. This refers to logging through vShield only.
    Enabled Select Enabled.
  9. Click OK to save the changes.
  10. Click Publish Changes.
  11. Follow the same steps and create a block-all rule for L2 and click Publish Changes. .

    Note

    These are ACL rules. So, you must define these block-all rules right at the top for both L3 and L2.