The new docs.trellix.com features a modernized UI and AI-powered conversational search. Content is currently available in English, with additional languages launching in early November 2026. We hope you enjoy the updated experience.

Press CTRL+K to open search

Install a new power supply

  • Published on Sep 17, 2026
  • 1 minute(s) read
Prev Next

  1. Unpack the power supply from its shipping carton.

  2. Remove the faceplate panel covering the power supply slot.

    Note

    The faceplate panel must remain in place unless a power supply is in the power supply slot. Do not operate the Sensor without the faceplate panel in place.

  3. Place the power supply in the slot with the cable outlet facing front and on the left side of the faceplate.

  4. Slide in the power supply until it makes contact with the backplane, then push firmly to mate the connectors solidly with the backplane.

    Note

    For true redundant operation with the power supply, Trellix recommends that you plug each supply into a different power circuit. For optimal protection, use uninterruptable power sources.

Copyright © 2026 Musarubra US LLC | Privacy | Legal | AI Disclaimer