Steps:
Unpack the power supply from its shipping carton.
Remove the faceplate panel covering the power supply slot.
Note
The faceplate panel must remain in place unless a power supply is in the power supply slot. Do not operate the Sensor without the faceplate panel in place.
Place the power supply in the slot with the cable outlet facing front and on the left side of the faceplate.
Slide in the power supply until it makes contact with the backplane, then push firmly to mate the connectors solidly with the backplane.
Note
For true redundant operation with the optional redundant power supply, Trellix recommends that you plug each supply into a different power circuit. For optimal protection, use uninterruptible power sources.