--- title: "Install Suricata software on an NS9600 Sensor" slug: "install-suricata-software-on-an-ns9600-sensor" tags: ["Hardware"] updated: 2026-09-17T10:17:59Z published: 2026-09-17T10:17:59Z canonical: "docs.trellix.com/install-suricata-software-on-an-ns9600-sensor" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Install Suricata software on an NS9600 Sensor Follow these steps to perform a fresh installation of the Suricata Sensor software on an NS9600 Sensor currently in IPS mode: **Steps:** 1. Deploy or load the image: Deploy or load the Suricata Sensor software image onto the Sensor. 2. Delete the Sensor from the Manager (if applicable): If the Sensor was previously configured, delete it from the Manager interface. 3. Reset the configuration: Run the `resetconfig` command to clear the previous configuration. > [!TIP] > Tip > > The `resetconfig` command includes an implicit Sensor reboot. 4. Change the mode to Suricata: Run the CLI command to change the Sensor mode to **Suricata** and reboot the device. For more information, see *Configure Sensor information*. 5. Add the Sensor to the Manager: Add the Sensor to the Manager. For more information, see *Add a Suricata Sensor as a standalone to the Manager* or *Add a Suricata Sensor as a stack to the Manager*.