--- title: "Install the passive fail-open switch in a rack" slug: "install-the-passive-fail-open-switch-in-a-rack" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/install-the-passive-fail-open-switch-in-a-rack" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Install the passive fail-open switch in a rack **Prerequisites:** - Identify the rack in which you plan to install the fail-open switch. - If you are using a physical Sensor, make sure that you can physically connect the fail-open switch with the monitoring ports. You can install between one and three fail-open switches in a rack-mount panel. The rack-mount panel described in this section is included in the contents of the fail-open kit. > [!NOTE] > Note > > This procedure is optional; if you do not want to install the fail-open in a rack, you can set up the switch directly on top of the Sensor or another network device. **Steps:** 1. Slide the switch into the center opening in the rack-mount panel, until the face plate of the switch rests against the panel. 2. Secure the switch to the rack-mount panel by inserting screws provided through the holes on the fail-open switch face plate and into the panel. ![GUID-E86F77BB-FEA2-4067-B1F3-71F07E336F37-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-4df784b4-9bb8-7853-56c3-7d7ce73e9b9a(1).png?sv=2026-02-06&spr=https&st=2026-11-20T15%3A52%3A57Z&se=2026-11-20T16%3A52%3A57Z&sr=c&sp=r&sig=06ESX3hkDSnyGiyF3hQHiUVbxt3NpKhmOTd%2FPlnrxT4%3D) > [!NOTE] > Note > > Additional fail-open switches can be installed without removing the rack-mount panel from the rack. 3. Place the 1U panel against the front of a standard 19-inch rack. 4. Secure the rack-mount panel by inserting screws (included with the rack-mount panel) through the holes on the front of the panel and the sides of the rack. 5. (Optional) Install up to two additional switches by following these steps: 1. Remove screws holding one of the removable blank plates from the front of the panel. 2. Follow steps 1 and 2 of this procedure for installing a switch in the rack-mount panel for additional fail-open switches. **Result:** The fail-open switch is ready to be connected to a Sensor.