Install the slide rails and rack mount the Sensor

Follow this procedure to assemble the slide rails and position the Sensor on it.

Note
Due to the weight of the appliance, Trellix recommends that two people place the chassis into the rail cabinet.

Disassemble the inner slide rails from the rail assemblies.
1. Pull the inner rail out.
2. Click and pull the white tab (lock on inner rail) forward to disconnect inner rail from the middle rail.
  The Inner rail is disconnected.
3. Push tab (a) to slide the middle rail back into the outer rail.
  The middle rail is pushed back into the outer rail.
Mount the inner rail onto the chassis unit.
1. Place each inner rail on both sides of the chassis unit. Position the three key holes of the inner rails with the mounting holes on the chassis unit.
2. Slide the rails forward to lock it.
Mount the outer slide rails/brackets to the rack posts.
1. Install the rear brackets to the rack. Push the latch forward to ensure the latch is completely installed in the rack posts.
2. Install the front brackets to the rack. Pull the front securing latch bracket and insert the pegs into the rack holes. Push the securing latch onto the rack post.
Mount the chassis unit into the rack.
1. Pull the middle rail out, extend it until the lock position.
  Note
  Ensure ball bearing retainer is located at the front of the middle rail.
2. Insert the chassis unit into the middle rails.
3. Pull or push the blue release tab on both sides and continue to push the chassis unit until fully closed.
4. Secure the chassis unit by locking it. Add thumb screws on both the sides of the rack post.