--- title: "Installing licenses using the CLI" slug: "installing-licenses-using-the-cli" updated: 2026-08-25T21:18:18Z published: 2026-08-25T21:18:18Z canonical: "docs.trellix.com/installing-licenses-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Installing licenses using the CLI Use the CLI commands in this topic to install licenses on the CMS appliance. Prerequisites - Admin or Operator access To install licenses: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Install each license: ``` hostname (config) # license install ``` ### Note You can enter the license keys sequentially separated by spaces as shown above, or enter `license install` and then press Enter to be prompted to enter the license keys one at a time. 3. Verify the licenses: ``` hostname (config) # show licenses License 1: LK2-FIREEYE_APPLIANCE-0000-0000-0000-0000-0000-0000-0000-0000-0000 Feature:             FIREEYE_APPLIANCE Description:         FireEye Appliance Valid:               yes Start date:          2016/11/21 (ok) Tied to Appl ID:     000000000000 (ok) Product:             eMPS (ok) Type:                PROD (ok) Agreement:           EULA (ok) Active:              yes ... License 2: LK2-CONTENT_UPDATES-0000-0000-0000-0000-0000-0000-0000-0000-0000 Feature:             CONTENT_UPDATES Description:         Content updates Valid:               yes Start date:          2016/11/21 (ok) End date:            2017/11/21 (ok) Tied to Appl ID:     000000000000 (ok) Sharing:             all (ok) Active:              yes License 3: LK2-FIREEYE_SUPPORT-0000-0000-0000-0000-0000-0000-0000-0000-0000 Feature:             FIREEYE_SUPPORT Description:         FireEye Support Valid:               yes Start date:          2016/11/21 (ok) End date:            2017/11/21 (ok) Tied to Appl ID:     000000000000 (ok) Sharing:             all (ok) Active:              yes ... ``` 4. Save your changes: ``` hostname (config) # write memory ``` :