--- title: "Internal switch port configuration and packet forwarding issues" slug: "internal-switch-port-configuration-and-packet-forwarding-issues-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:23Z published: 2026-11-19T12:28:23Z canonical: "docs.trellix.com/internal-switch-port-configuration-and-packet-forwarding-issues-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Internal switch port configuration and packet forwarding issues The following CLI commands provide insight into the Sensor internal switch port configuration. It also helps troubleshoot packet forwarding issues. - Use `bcmcli "<string input of the bcm>"` command to retrieve bcm process output from the primary unit. For example: `bcmcli "ps"` > [!NOTE] > Note > > This command is applicable to NS-series Sensors. - Use `bcmcli-sec "<string input from the secondary unit bcm>"` command to retrieve the bcm process output of secondary unit on primary unit. This command is applicable for primary unit alone. For example: `bcmcli-sec "ps"` > [!NOTE] > Note > > This command is applicable to NS9300 Sensors only. Trellix recommends you not to execute these commands without the help of Trellix Support as it might cause Sensor issues based on the parameter given. In case you encounter a problem, contact Trellix Support for further assistance.