When a high latency is observed on the Sensor and the latency monitor is configured, the Sensor remains in layer 2 until a layer 2 deassert is invoked or a Sensor reboots. This command allows the Sensor to come out of layer 2 mode without layer 2 deassert. The Sensor restores to inline from layer 2 if the following conditions are met:
The latency monitor has put the Sensor in layer 2 mode.
The Sensor is in good health. If the Sensor is in bad health, a deassert cannot be performed and the Sensor reboots.
A substantial amount of time has lapsed, as configured using this command, when the Sensor went into layer 2 due to latency. The default time to trigger an automatic layer 2 deassert is 10 minutes.
If the latency continues to exist after the Sensor is restored to inline mode, the Sensor behaves as per the current setting of the latency monitor.
Syntax
latency-monitor restore-inline enable <10-60>
latency-monitor restore-inline disable
Parameter | Description |
|---|---|
<10-60> | The time to trigger the restore inline from layer 2. It is counted since the time the Sensor moved into layer 2 state due to high latency. |
The latency-monitor status command displays the current status of the latency monitor feature, as well as the current status of the restore-inline feature of the latency monitor.
Applicable to:
NS-series Sensors