This command enables you to configure the Layer 2 mode.
Syntax:
layer2 mode <assert | deassert> <port>
| Parameter | Description |
|---|---|
| assert | Forces the Sensor port into Layer 2 Pass-Through Mode (also known as L2 Mode). This helps in troubleshooting network issues. When this command is used, the Sensor stays in L2 Mode until one of two events occurs: either during the Sensor reboot or when the layer2 mode deassert command is issued. |
| deassert | Forces the Sensor port out of Layer 2 Pass-Through Mode. It is used to re-establish IPS processing after the layer2 mode assert command is issued. This command must not be used to force a Sensor out of L2 Mode if L2 Mode was triggered by a Sensor software failure. Using the command in this manner triggers a Sensor reboot. |
| port | Sets the port for which assert or deassert action needs to be performed.
Valid port numbers are: G0/1 | G0/2 | G1/1 | G1/2 | G1/3 | G1/4 | G1/5 | G1/6 | G1/7 | G1/8 | G1/9 | G1/10 | G1/11 | G1/12 | G2/1 | G2/2 | G2/3 | G2/4 | G2/5 | G2/6 | G2/7 | G2/8 | G2/9 | G2/10 | G2/11 | G2/12 | G3/1 | G3/2 | G3/3 | G3/4 | G3/5 | G3/6 | G3/7 | G3/8 |
Default Value:
OnSample Output:
IntruDbg#> layer2 mode assert g0/1-g0/2
Note
To check the Layer 2 configuration on individual interface, run show layer2 portlevel command.
Applicable to:
NS7x00, NS7x50, NS7500, NS9x00, and NS9500 Sensors