---
title: "layer2 mode"
slug: "layer2-mode"
tags: ["Product Usage", "IPS 10.1.10"]
updated: 2026-10-05T15:40:40Z
published: 2026-10-05T15:40:40Z
canonical: "docs.trellix.com/layer2-mode"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# layer2 mode
This command enables you to configure the Layer 2 mode.
**Syntax:**
layer2 mode <assert | deassert> <port>
| Parameter | Description |
| --- | --- |
| assert | Forces the Sensor port into Layer 2 Pass-Through Mode (also known as L2 Mode). This helps in troubleshooting network issues. When this command is used, the Sensor stays in L2 Mode until one of two events occurs: either during the Sensor reboot or when the layer2 mode deassert command is issued. |
| deassert | Forces the Sensor port out of Layer 2 Pass-Through Mode. It is used to re-establish IPS processing after the layer2 mode assert command is issued. This command must not be used to force a Sensor out of L2 Mode if L2 Mode was triggered by a Sensor software failure. Using the command in this manner triggers a Sensor reboot. |
| port | Sets the port for which assert or deassert action needs to be performed. Valid port numbers are: G0/1 \| G0/2 \| G1/1 \| G1/2 \| G1/3 \| G1/4 \| G1/5 \| G1/6 \| G1/7 \| G1/8 \| G1/9 \| G1/10 \| G1/11 \| G1/12 \| G2/1 \| G2/2 \| G2/3 \| G2/4 \| G2/5 \| G2/6 \| G2/7 \| G2/8 \| G2/9 \| G2/10 \| G2/11 \| G2/12 \| G3/1 \| G3/2 \| G3/3 \| G3/4 \| G3/5 \| G3/6 \| G3/7 \| G3/8 |
**Default Value:**
On
**Sample Output:**
IntruDbg#> layer2 mode assert g0/1-g0/2
> [!NOTE]
> Note
>
> To check the Layer 2 configuration on individual interface, run show layer2 portlevel command.
**Applicable to:**
NS7x00, NS7x50, NS7500, NS9x00, and NS9500 Sensors