The Management (Mgmt) port uses a Cat 5/Cat 5e cable.
| Pin # | Signal | Direction on Sensor |
|---|---|---|
| 1 | TxD+ | Output |
| 2 | TxD- | Output |
| 3 | RxD+ | Input |
| 4 | These pins are terminated to ground through a 75 ohm resistor & capacitor. | |
| 5 | ||
| 6 | RxD- | Input |
| 7 | These pins are terminated to ground through a 75 ohm resistor & capacitor. | |
| 8 | ||
Note
Category 5 Enhanced (Cat 5e) cable is required for transmission speeds up to 1 Gigabit per second (Gigabit Ethernet). For Ethernet networks running at 10 or 100 Mbps, Category 5 (Cat 5) OR Cat 5e cable can be used.
Note
Throughout this guide, cabling specifications will be mentioned as Cat 5/Cat 5e.