The Management (Mgmt) port uses a Cat 5/Cat 5e cable.
Pin # | Signal | Direction on Sensor |
|---|---|---|
1 | TxD+ | Output |
2 | TxD- | Output |
3 | RxD+ | Input |
4 | These pins are terminated to ground through a 75 ohm resistor & capacitor. | |
5 | ||
6 | RxD- | Input |
7 | These pins are terminated to ground through a 75 ohm resistor & capacitor. | |
8 | ||
Note
Category 5 Enhanced (Cat 5e) cable is required for transmission speeds up to 1 Gigabit per second (Gigabit Ethernet). For Ethernet networks running at 10 or 100 Mbps, Category 5 (Cat 5) OR Cat 5e cable can be used.
Note
Throughout this guide, cabling specifications will be mentioned as Cat 5/Cat 5e.