--- title: "mvx mode sensor" slug: "mvx-mode-sensor" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:23:03Z published: 2026-08-04T17:23:03Z canonical: "docs.trellix.com/mvx-mode-sensor" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # mvx mode sensor Enables an integrated appliance to operate in MVX "sensor" mode, in which the appliance sends all submissions to an MVX cluster for detection and analysis, instead of sending submissions to its on-board MVX analysis engine. By default, ether1 is the submission interface (used for communication between the appliance and the MVX cluster). Trellix recommends that you configure another management interface (such as ether2) for the submission interface. This prevents the ether1 management interface from becoming too busy, and keeps management and data traffic separate. If you change from local mode or hybrid mode to sensor mode, must reload the appliance for the change to take effect. > [!NOTE] > Note > > An integrated appliance is a physical appliance with an on-board MVX analysis engine. ### Syntax `mvx mode sensor` ### Parameters None ### Example The following example enable sensor mode on the nx-2 appliance. ``` nx-2 (config) # mvx mode sensor MVX sensor mode configuration successful. Please reload the appliance to come up in the configured mode ``` ### User role Admin ### Command mode Config ### Supported appliances This command is supported on the following appliances running the specified releases or later: **Network Security:** Release 8.0.0 > [!NOTE] > Note > > This command replaces the `mvx sensor enable` command, which was introduced in Network Security Release 7.9.0.