--- title: "Network ports flap consistently due to routing protocol interval" slug: "network-ports-flap-consistently-due-to-routing-protocol-interval-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:51Z published: 2026-11-19T12:30:51Z canonical: "docs.trellix.com/network-ports-flap-consistently-due-to-routing-protocol-interval-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Network ports flap consistently due to routing protocol interval If the two-port link is enabled by default and the two-port link timeout has a value lower than the routing protocol hello interval in the network devices, the network ports flap consistently. > [!NOTE] > Note > > To view this issue, login to the web interface and select the **Log file** tab. Under **Log file view**, click **>|**. Perform the following steps in the CLI to troubleshoot the issue: 1. Change the 2pl timeout to a higher value than routing protocol hello interval. `set_2pl_link_timeout <4-25>sec` 2. If problem persists after changing the 2pl timeout to the highest value (25 seconds), turn off 2pl. `set_2pl off` > [!NOTE] > Note > > Setting the two-port link off disables the LFD feature on the network side. That is, if one side of the network goes down, the peer side stays up which results in routing issue and network traffic outages.