If the two-port link is enabled by default and the two-port link timeout has a value lower than the routing protocol hello interval in the network devices, the network ports flap consistently.
Note
To view this issue, login to the web interface and select the Log file tab. Under Log file view, click >|.
Perform the following steps in the CLI to troubleshoot the issue:
Change the 2pl timeout to a higher value than routing protocol hello interval.
set_2pl_link_timeout <4-25>secIf problem persists after changing the 2pl timeout to the highest value (25 seconds), turn off 2pl.
set_2pl offNote
Setting the two-port link off disables the LFD feature on the network side. That is, if one side of the network goes down, the peer side stays up which results in routing issue and network traffic outages.