--- title: "(Or) Connect a fiber fail-open switch" slug: "or-connect-a-fiber-fail-open-switch" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/or-connect-a-fiber-fail-open-switch" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # (Or) Connect a fiber fail-open switch **Prerequisites:** - You will require two LC-LC cables to connect your fail-open switch to the Sensor. - If you are connecting a 1-Gigabit fail-open switch, you will require two fiber SFPs to be inserted into two corresponding blank ports on the Sensor. - If you are connecting a 10-Gigabit fail-open switch, you will require two fiber SFP+s to be inserted into two corresponding blank ports on the Sensor. > [!TIP] > Tip > > For more details about the SFP/SFP+ compatible with your Sensor, refer to the *Trellix Intrusion Prevention System NS-series Sensor Product Guide* for the appropriate model. **Steps:** 1. Connect an LC-LC cable into the LC receptacle of port **Gy/a** or **xA**, where **y** represents the module number (for NS-Series Sensors), and **x** and **a** are the port numbers. 2. Connect the other end of the LC cable to the LC receptacle labeled **Mon 0** of the fail-open switch. 3. Connect an LC-LC cable to the corresponding **Gy/b** or **xB** peer port. (For example, if you used **G1/3** in step 1, plug the cable into port **G1/4**). 4. Connect the other end of this cable to the port labeled **Mon 1** of the fail-open switch. **Result:** With this cable configuration, Sensor Monitoring port **Gy/a** or **xA** views traffic as originating inside the network, and port **Gy/b** or **xB** views traffic as originating outside the network. Note that this configuration (**Gy/a** or **xA** = outside, **Gy/b** or **xB** = inside) must match the port configuration specified for this Sensor, and that the ports must be configured accordingly.