--- title: "policymgr interface <port-pair-name> drop out-interface" slug: "policymgr-interface-port-pair-name-drop-out-interface" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:23:18Z published: 2026-08-04T17:23:18Z canonical: "docs.trellix.com/policymgr-interface-port-pair-name-drop-out-interface" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # policymgr interface <port-pair-name> drop out-interface Configures when a specific A or B monitoring interface is for out-of-band TAP mode blocking with TCP reset, UDP, or HTTP enabled on the appliance interface. > [!WARNING] > Important > > You must use the `policymgr interface <port-pair-name> re-configure` command for the changes to take effect. ### Syntax `policymgr interface <port-pair-name> drop out-interface {ether1 | ether2}` ### Parameters `<port-pair-name>` Designation (A or B) that is configured on the appliance interface. `ether1` Configures the ether1 management interface to block packets that are sent in response to outbound traffic by the Network Security appliance. `ether2` Configures the ether2 management interface to block packets that are sent in response to outbound traffic by the Network Security appliance. ### Example The following example shows how to configure the ether2 management interface to block packets that are sent in response to outbound traffic by the Network Security appliance. ``` hostname  (config) # policymgr interface A drop out-interface ether2 hostname(config) # policymgr interface A re-configure ``` ### User role Admin or Operator ### Command mode Config ### Supported appliances This command is supported on the following appliances running the specified releases or later: - **Network Security:** Before Release 7.5