--- title: "policymgr interface <port-pair-name> op-mode block" slug: "policymgr-interface-port-pair-name-op-mode-block" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:23:18Z published: 2026-08-04T17:23:18Z canonical: "docs.trellix.com/policymgr-interface-port-pair-name-op-mode-block" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # policymgr interface <port-pair-name> op-mode block Configures inline blocking and a fail-safe mode on the appliance interface. This command is not supported on SmartVision Edition appliances, which are Network Security appliances with SmartVision Edition appliance licenses. The SmartVision Edition sensor is also called Trellix Network Security, SmartVision Edition. > [!WARNING] > Important > > You must use the `policymgr interface <port-pair-name> re-configure` command for the changes to take effect. > [!WARNING] > Caution > > If you configure the fail-safe close inline blocking, you must use active end-to-end monitoring of the device to enable the rerouting of traffic of the device fails. ### Syntax `policymgr interface <port-pair-name> op-mode block [fail-safe {open | close}`] ### Parameters `<port-pair-name>` Designation (A or B) that is configured on the appliance interface. `[fail-safe {open}]` Allows all packets to pass through the appliance in case software, hardware, or power fails. `[fail-safe {close}]` Blocks all traffic in case of software, hardware, or power fails. This parameter should only be used if the device is actively monitored. ### Examples The following example configures inline blocking on the specified interface. ``` hostname (config) # policymgr interface A op-mode block hostname (config) # policymgr interface A re-configure ``` The following example sets the fail-safe for inline blocking on the specified interface ``` hostname (config) # policymgr interface B op-mode block fail-safe open hostname (config) # policymgr interface B re-configure ``` ### User role Admin or Operator ### Command mode Config ### Supported appliances This command is supported on the following appliances running the specified releases or later: - **Network Security:** Before Release 7.5