--- title: "policymgr ssl-intercept network ip interface pass-through" slug: "policymgr-ssl-intercept-network-ip-interface-pass-through" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:23:18Z published: 2026-08-04T17:23:18Z canonical: "docs.trellix.com/policymgr-ssl-intercept-network-ip-interface-pass-through" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # policymgr ssl-intercept network ip interface pass-through Adds a rule to a network policy that bypasses traffic either to or from a specified IPv4 or IPv6 address and mask. When you configure rules for a network policy on the Network Security appliance, you can control which traffic to whitelist based on the destination IP address, source IP address, or mask. You can configure rules for a specified network port pair or all network port pairs. You can configure multiple network policy rules with different subnets for your organization. > [!WARNING] > Important > > You must enter each rule separately. You can add up to 512 rules to the network policy. The network policy rules are optional. For details about how to add a rule to a network policy, see the "Configuring SSL Interception" chapter of the Network Security User Guide. ### Syntax `policymgr ssl-intercept network ip <IP_address>|<prefix>|<any> interface <port-pair-name> pass-through` ### Parameters `<IP_address|<prefix>|<any>` IP source or destination address for the network policy rule. To match any IP address for the network port pair, enter any. `<port-pair-name>` Network port pair designation (A through F) that is configured on the appliance interface. To specify all the network port pairs, enter `ALL`. `pass-through` Bypass traffic matching the rule. ### Example The following example adds a rule to a network policy that bypasses traffic matching the specified IPv4 address and mask. ``` hostname (config) # policymgr ssl-intercept network ip 12.23.22.0/24 interface A pass-through ``` The following example adds a rule to a network policy that decrypts traffic matching the specified based on the IPv6 address and mask: ``` hostname (config) # policymgr ssl-intercept network ip 2002:470:84a7:1720:ae1f:6bff:fe12:3e03/128 interface A pass-through ``` ### User role Admin or Operator ### Command mode Config ### Supported appliances This command is supported on the following appliances running the specified releases or later: - **Network Security:** Release 8.2.1. Support to add up to 512 rules to the network policy was added in Release 8.3.2.