--- title: "Preparing an File Protect appliance to send a management request in a NAT deployment" slug: "preparing-file-protect-appliance-send-management-request-nat-deployment-1" updated: 2026-09-08T22:56:48Z published: 2026-09-08T22:56:48Z canonical: "docs.trellix.com/preparing-file-protect-appliance-send-management-request-nat-deployment-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Preparing an File Protect appliance to send a management request in a NAT deployment Use the commands in this section to prepare an appliance in a NAT deployment to send a request for management to the Central Management System appliance. To prepare to send a request: 1. Log in to the File Protect CLI. 2. Go to CLI configuration mode: ``` appl-hostname > enable appl-hostname # configure terminal ``` 3. Enable automatic rendezvous attempts: ``` appl-hostname (config) # cmc rendezvous client auto ``` ### Important After automatic rendezvous is enabled, when the requesting File Protect appliance is behind a NAT gateway, the local IP address of the appliance will be included in the request instead of the mapped address. You must prevent the local IP address of the appliance from being part of the request, and then force the request to be sent again using the mapped address. These commands are included in the relevant procedures. 4. Verify that the auto connect feature is enabled: 1. View File Protect (client) information: ``` appl-hostname (config) # show cmc client ``` 2. If` Autoconnect: no `is shown, enable auto connect: ``` appl-hostname (config) # cmc client connection auto ``` 5. Save your changes. ``` hostname (config) # write memory ``` :