--- title: "Preparing an Intelligent Virtual Execution - Server appliance to send a management request in a NAT deployment" slug: "preparing-intelligent-virtual-execution-server-appliance-send-management-request" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Network Security"] updated: 2026-08-24T20:40:19Z published: 2026-08-24T20:40:19Z canonical: "docs.trellix.com/preparing-intelligent-virtual-execution-server-appliance-send-management-request" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Preparing an Intelligent Virtual Execution - Server appliance to send a management request in a NAT deployment Use the commands in this section to prepare an appliance in a NAT deployment to send a request for management to the Central Management System appliance. **To prepare to send a request:** 1. Log in to the Intelligent Virtual Execution - Server CLI. 2. Go to CLI configuration mode: ``` appl-hostname > enable appl-hostname # configure terminal ``` 3. Enable automatic rendezvous attempts: ``` appl-hostname (config) # cmc rendezvous client auto ``` > [!WARNING] > Important > > After automatic rendezvous is enabled, when the requesting Intelligent Virtual Execution - Server appliance is behind a NAT gateway, the local IP address of the appliance will be included in the request instead of the mapped address. You must prevent the local IP address of the appliance from being part of the request, and then force the request to be sent again using the mapped address. These commands are included in the relevant procedures. 4. Verify that the auto connect feature is enabled: 1. View Intelligent Virtual Execution - Server (client) information: ``` appl-hostname (config) # show cmc client ``` 2. If `Autoconnect: no` is shown, enable auto connect: ``` appl-hostname (config) # cmc client connection auto ``` 5. Save your changes. ``` hostname (config) # write memory ```