This command repairs the RAID1 SSD component exhibiting a fault. Select raidrepair current <ssd0|ssd1> to repair the faulty SSD within the Sensor.
Select raidrepair new <ssd0|ssd1> to replace the faulty SSD with a new SSD, and to restore the data on RAID1 it synchronizes the data of the healthy SSD with the new SSD.
Note
RAID is not supported on NS7500, NS7x50, NS7x00, NS5x00, NS3500, and NS3x00 Sensors.
Syntax:
raidrepair <new|current> <ssd0|ssd1>
| Parameter | Description |
|---|---|
| new | When a complete reimage of a single disk is required |
| current | When the disk is corrupted |
| ssd0 | Disk is located in the upper bay within the chassis. |
| ssd1 | Disk is located in the lower bay within the chassis. |
Applicable to:
NS9500, NS9300, NS9200, and NS9100 Sensors