--- title: "reboot" slug: "reboot-6" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:52Z published: 2026-11-19T12:29:52Z canonical: "docs.trellix.com/reboot-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # reboot This command is used to reboot a device. You must confirm that you want to reboot the device. If hitless reboot is currently available for the device, you are prompted to enter 'h' for hitless and 'y' for a full reboot. Use the `status` command to know if the hitless reboot option is currently available for the device. > [!NOTE] > Note > > In case of a full reboot, all the processes of a device are restarted. So, there is a break in the device's function until it comes up again. In case of hitless reboot, only the required processes are restarted. For more information on hitless reboot, see the topic *How to reboot devices* in the *IPS Administration* section. For NS-series Sensors, you must do a full reboot as hitless reboot is not supported when SSL decryption is enabled. **Syntax:** `reboot` On executing the command for Sensor, the following messages are displayed in the output: `intruShell@john> reboot` `Please enter Y to confirm: y` `rebooting the Sensor...` `Broadcast message from root (Fri Mar 29 05:45:14 2014):` `The system is going down for reboot NOW!` **Applicable to:** NS-series Sensors