--- title: "Recovering malware-object events after a failure using the CLI" slug: "recovering-malware-object-events-after-a-failure-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-12T20:32:10Z published: 2026-09-12T20:32:10Z canonical: "docs.trellix.com/recovering-malware-object-events-after-a-failure-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Recovering malware-object events after a failure using the CLI Use the commands in this section to recover malware-object events. Perform this procedure from the peer appliance, not from the appliance that failed. To recover malware-object events: 1. Log in to the peer appliance. 2. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal hostname (config) # ``` 3. Recover the events: ``` hostname (config) # object-analysis salvage from "YYYY/MM/DD HH:MM:SS" ``` where `YYYY/MM/DD HH:MM:SS` is the date and time from which to start recovering events. The number of salvaged objects will be displayed. ### Note You can also view the number of salvaged objects using the `show object-analysis` command. 4. Save your changes: ``` hostname (config) # write memory ``` ##### Example The following example salvages the objects that passed through the defective appliance's monitoring port after 12:00 noon on January 25, 2016. ``` hostname (config) # object-analysis salvage from "2016/01/25 12:00:00" Total objects salvaged: 25 nx-2 (config) # show object-analysis ... Total salvaged object analysis entries   :    25 ``` :