--- title: "Redundant Sensors on a single path" slug: "redundant-sensors-on-a-single-path-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:59Z published: 2026-11-19T12:30:59Z canonical: "docs.trellix.com/redundant-sensors-on-a-single-path-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Redundant Sensors on a single path Trellix IPS is engineered to seamlessly slip onto networks within existing networks and between redundant paths. This simplifies implementing a Sensor HA pair in complicated environments. However, introducing a Sensor HA pair in a network with a single path requires additional effort. A pair of Sensors can run in parallel on a network as shown in the following figure. ![GUID-9516951A-B33E-4E37-9B56-880B6E9E4C3C-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-76d5fb5b-145b-0197-4b1b-e75899be1d3c(7).png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A28%3A47Z&se=2026-11-20T12%3A28%3A47Z&sr=c&sp=r&sig=Vp%2B302caKVOAGKRBQG6k8Vu3xilfen%2Bn6YKnFpOZcZE%3D) Here, a pair of Sensors are "sandwiched" between a pair of switches and STP is used to control the failover process. However, this causes one Sensor to be redundant, unless a fail-over occurs. This in turn complicates the Layer 2 infrastructure and causes a latency of 12 to 50 seconds due to the STP convergence. Instead, consider the configuration in the below figure for a single path: **Stack configuration**![Stack Configuration](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-5d1fcc36-c0a2-df29-d0a7-b3a83d080274(7).png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A28%3A47Z&se=2026-11-20T12%3A28%3A47Z&sr=c&sp=r&sig=Vp%2B302caKVOAGKRBQG6k8Vu3xilfen%2Bn6YKnFpOZcZE%3D) > [!NOTE] > Note > > To view the list of failover ports used for each Sensor model refer to [HA pair cable connections](/network-and-platform/docs/ha-pair-cable-connections-2). If you are using stacked Sensors, the failover port is G1/1. These Sensors are configured to run inline, failopen, and function as a HA pair. The advantages of this redundant configuration over others on a network with a single path are as follows: - There is no dependency on Layer 2 or Layer 3 topologies for Sensor redundancy. - If one Sensor fails, it fails open, and the other Sensor continues to scan with no interruption. - Because they are configured as a HA pair, state will be maintained. The disadvantages of this redundant configuration are as follows: - Duplicate alerts are generated for UDP and ICMP attacks. - Latency is induced as the packets traverse across two Sensors instead of one.