--- title: "Remote Monitoring and Management for the Linux-based Manager Appliance" slug: "remote-monitoring-and-management-for-the-linux-based-manager-appliance" updated: 2026-09-17T11:03:19Z published: 2026-09-17T11:03:19Z canonical: "docs.trellix.com/remote-monitoring-and-management-for-the-linux-based-manager-appliance" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Remote Monitoring and Management for the Linux-based Manager Appliance This procedure guides the configuration of Remote Monitoring and Management (RMM) for the Linux-based Manager Appliance. To begin configuration, you must first access the device's CLI: - Connect to the physical serial port on the back of the appliance. OR - Connect directly to the appliance's Trellix OS configuration interface. ### Tip IPMI user passwords are set to a random value by default and must be reset in the CLI. **Setting IPMI user password** - At the command prompt, use the following command to set the IPMI user password. ``` ipmi user set password ``` Example: **`IPSManager (config) # ipmi user set password Trellix123! Set User Password command successful (user 2)`** **Configuring IPMI network parameters** You can configure the network parameters using either DHCP for dynamic assignment or static IP addressing. 1. **Use DHCP for dynamic IP assignment** 1. Enable IPv4 networking for IPMI. ``` ipmi enable nwtype ipv4 ``` 2. Set the IPMI LAN IP source to DHCP. ``` ipmi lan ipsrc dhcp ``` 2. **Use static IP assignment** 1. Enable IPv4 networking for IPMI. ``` ipmi enable nwtype ipv4 ``` 2. Set the static default gateway for the IPMI LAN. ``` ipmi lan defgw 10.10.10.11 ``` 3. Set the static IP address for the IPMI LAN. ``` ipmi lan ipaddr 10.10.10.12 ``` :