--- title: "Remove an active Fail-Open module from the chassis" slug: "remove-an-active-fail-open-module-from-the-chassis" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/remove-an-active-fail-open-module-from-the-chassis" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Remove an active Fail-Open module from the chassis **Prerequisite:** You must make sure the Fail-Open module is fully powered off before you attempt to remove it from the chassis. > [!NOTE] > Note > > Trellix recommends you power off the Fail-Open module before removing it from its slot. The module can be individually powered down by pressing the corresponding M1 M2 or M3 button for at least 4 seconds. If you replace a module with the same type, the replaced module will be active after insertion and does not require a reboot of the system. Follow the steps in this section to power off and remove the Fail-Open module. **Steps:** 1. Power off the Fail-Open module using the web interface or CLI command prompt. - If you are using the web interface, click the **Rescue** tab and check the **Power Off** checkbox in the **System Restore** section. To access the web interface, refer to the section [Manage the fail-open switch through a web interface](/network-and-platform/docs/manage-the-active-fail-open-module-through-a-web-interface-1). ![GUID-04A52392-5655-4BF0-94EC-5F07CD88CE50-low.jpg](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-761593b8-9257-e13e-9f96-50a5f8d9753d.jpg?sv=2026-02-06&spr=https&st=2026-11-20T19%3A49%3A40Z&se=2026-11-20T20%3A49%3A40Z&sr=c&sp=r&sig=W7AxO8itN6bKVI2aMCQ1QsnNHL5IWcgXygOHIQ0NTws%3D) - If you are using the CLI command prompt, type `power_off` and press **Enter**. To access the CLI prompt, refer to the section [Configure fail-open switch parameters](/network-and-platform/docs/configure-active-fail-open-chassis-parameters). 2. When the Fail-Open module is powered off, remove the captive screws and slide it out of the chassis.