--- title: "Removing an appliance from a Network Security HA pair using the CLI" slug: "removing-an-appliance-from-a-network-security-ha-pair-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-12T20:32:10Z published: 2026-09-12T20:32:10Z canonical: "docs.trellix.com/removing-an-appliance-from-a-network-security-ha-pair-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Removing an appliance from a Network Security HA pair using the CLI Use the commands in this section to delete a member of a Network Security HA pair. To remove an appliance from an HA pair: 1. Log in to the Central Management System CLI. 2. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal hostname (config) # ``` 3. Delete the appliance: ``` hostname (config) # no cmc ha nx appliance ``` where `<pair>` is the name of the pair and `<member>` is the name of the appliance you want to remove. (The appliance name is displayed in the `show cmc appliances` command output). 4. Verify your change: ``` hostname (config) # show cmc ha nx ``` 5. Save your change: ``` hostname (config) # write memory ``` ###### Example The following example removes nx-2 from the Acme_NXHA pair. ``` hostname (config) # no cmc ha nx Acme_NXHA appliance nx-2 hostname (config) # show cmc ha nx NX-HA Acme_NXHA: nx-1      Status: Degraded    Comment:    NX-HA pair is degraded because not all members    are configured. ``` :