--- title: "Replacing a member of a Network Security HA pair using the CLI" slug: "replacing-a-member-of-a-network-security-ha-pair-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-12T20:32:10Z published: 2026-09-12T20:32:10Z canonical: "docs.trellix.com/replacing-a-member-of-a-network-security-ha-pair-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Replacing a member of a Network Security HA pair using the CLI Use the commands in this section to replace a member of a Network Security HA pair. To replace a member of a Network Security HA pair: 1. Log in to the Central Management System CLI. 2. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal hostname (config) # ``` 3. Create the pair again, but specify the name of the replacement member instead of the existing member: ``` hostname (config) # cmc ha nx appliances enable-nx-ipv6 ``` where `<existingMember>` is the name of the appliance you want to keep in the pair, `<replacementMember>` is the name of the appliance that will replace the other appliance in the pair, and `enable-nx-ipv6` allows the Central Management System appliance to enable IPv6 on the two appliances. (The appliance name is displayed in the`show cmc appliances` command output). 4. Verify your change: ``` hostname (config) # show cmc ha nx ``` 5. Save your change: ``` hostname (config) # write memory ``` ###### Example The following example replaces nx-2 with nx-3 in the Acme_NXHA pair. ``` hostname (config) # show cmc ha nx Acme_NXHA NX-HA Acme_NXHA nx-1 nx-2       Status: OK ... hostname (config) #cmc ha nx Acme_NXHA appliances nx-1 nx-3 enable-nx-ipv6 hostname (config) # show cmc ha nx Acme_NXHA NX-HA Acme_NXHA nx-1 nx-3        Status: OK ... ``` :