--- title: "resetconfig" slug: "resetconfig" tags: ["Reference", "IPS 10.1.10"] updated: 2026-09-23T09:41:20Z published: 2026-09-23T09:41:20Z canonical: "docs.trellix.com/resetconfig" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # resetconfig This command resets all configuration values to their default values. It deletes or resets values as described below. This command causes an automatic reboot of the Sensor. | **Deleted Values** | **Values Reset to Defaults** | | --- | --- | | - Manager address (and secondary interface's IP address, if configured). This can be IPv4 or IPv6 address. | - Monitoring and Response port settings | | - Certificates establishing trust between Sensor and Manager (shared key value) | - Management port settings | | - Signatures | - Manager Install port value | | - TFTP server IP address (IPv4 or IPv6 address) | - Manager Alert port value | | - SCP server IP address (IPv4 or IPv6 address) | - Manager Log port value | | - DoS profile files (learned DoS behavior) | | | - SSL Key | | | - Exception Object | | | - ACL | | | - Advanced Setting | | On executing the command, the following messages are displayed if the Sensor has CA-signed certificate: Do you want to retain the current CA signed certificate chain ? Enter Y/y(for yes) or N/n(for no): Y > [!NOTE] > Note > > If you enter **Y**, the CA-signed certificate chain for the Sensor is retained. If you enter **N**, both the current Sensor CA-signed certificate and self-signed certificate is removed along with the trust. Pressing **Y** displays the following message: Reset other configurations and reboot? Please enter Y to confirm: Y > [!NOTE] > Note > > If you enter **Y**, the Manager-Sensor trust is removed. If you enter **N**, the Manager-Sensor trust remains intact and you come out of the deinstall prompt. Pressing **Y** displays the following message: resetting the configuration and rebooting the sensor On executing the command, the following messages are displayed if the Sensor has self-signed certificate: reset the configuration and reboot? Please enter Y to confirm: Y Entering **Y** displays the following message: resetting the configuration and rebooting the sensor **Syntax**: resetconfig **Applicable to:** NS-series Sensors