--- title: "Resetting the IPMI interface using the CLI" slug: "resetting-the-ipmi-interface-using-the-cli" updated: 2026-08-25T21:18:33Z published: 2026-08-25T21:18:33Z canonical: "docs.trellix.com/resetting-the-ipmi-interface-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Resetting the IPMI interface using the CLI This procedure describes how to reset the IPMI interface. Prerequisites - Admin access to the CMS appliance. If the IPMI interface stops working, follow these steps to reset it. You might need to schedule a maintenance window to do this. To reset the IPMI interface: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Reload the IPMI firmware: ``` hostname (config) # ipmi firmware reload cold ``` 3. Wait five minutes. 4. Check whether the IPMI interface is up: ``` hostname (config) # show ipmi ``` 5. If the IPMI interface is down: 1. Shut down the appliance: ``` hostname (config) # reload halt ``` 2. Unplug all power cables. 3. Wait 90 seconds. 4. Plug in the power cables. 5. Push the power button to restart the appliance. :