--- title: "Restoring authentication for NTP service" slug: "restoring-authentication-for-ntp-service" updated: 2026-08-25T13:50:04Z published: 2026-08-25T13:50:04Z canonical: "docs.trellix.com/restoring-authentication-for-ntp-service" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Restoring authentication for NTP service Common Criteria compliance requires that NTP servers use SHA-1 authentication. After you apply compliance, NTP service may be interrupted. When you apply Common Criteria compliance, the following changes are made: - All MD5-authorized NTP peers are deleted from the configuration. MD5 authentication is not supported in FIPS or CC compliance. - Trellix NTP pool servers are removed from the configuration because they do not support SHA-1 authentication. If your configuration uses only unauthenticated peers or MD5-authenticated peers that are not compliant, no NTP peers remain after you apply compliance. If your configuration includes SHA-1-authorized NTP peers, they are retained. To restore NTP service, use one of the following options. - Configure your own NTP servers with SHA-1 authorization. This option is fully compliant. - Opt out of full formal compliance by re-enabling the unauthenticated Trellix NTP server pool. Use the `compliance options ntp-default-servers enable `command. - Opt out of full formal compliance by configuring your own NTP servers with MD5 authorization or no authorization. - Set the clock manually using the `clock set `command. This option is fully compliant but less accurate than the others. - Use a non-compliant method such as temporarily enabling `ntpd` or running the `ntpdate` command one time only. If you want the time synchronized from multiple NTP servers, configure and enable ntp and wait for the time to fully synchronize with all peers, then disable ntpd using `no ntp enable` immediately after the clock is synchronized. If you need the time from only one ntp server, use the`ntpdate` command to synchronize the clock with the specified server IP address. :