Please read the following warnings before you install the product. Failure to observe these safety warnings could result in serious physical injury.
Caution
Read the installation instructions before you connect the system to its power source.
Caution
To remove all power from the Sensor, unplug all power cords, including the redundant power cord.
Caution
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Caution
The Sensor has no ON/OFF switch. Plug the Sensor into a power supply ONLY after you have completed rack installation.
Caution
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals.
Caution
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.
Caution
Do not remove the outer shell of the Sensor. Doing so will invalidate your warranty.
Caution
Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Blank faceplates and cover panels prevent exposure to hazardous voltages and currents inside the chassis, contain electromagnetic interference (EMI) that might disrupt other equipment, and direct the flow of cooling air through the chassis.
Caution
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Caution
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the users will be required to correct the interference at their own expense.