Please read the following warnings before you install the Sensor. These safety measures apply to all Sensor models unless otherwise noted. Failure to observe these safety warnings could result in serious physical injury.
Warnings:
Read the installation instructions before you connect the system to its power source.
To remove all power from the Sensor, unplug all power cords, including the redundant power cord.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Before working on the equipment that is connected to power lines, remove all jewelry including rings, necklaces, and watches. Metal objects will heat up when connected to power and ground, and can cause serious burns or weld the metal object to the terminals.
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.
Do not remove the outer shell of the Sensor. Doing so will invalidate your warranty.
Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Blank faceplates and cover panels prevent exposure to hazardous voltages and currents inside the chassis, contain electromagnetic interference (EMI) that might disrupt other equipment, and direct the flow of cooling air through the chassis.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, might cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the users will be required to correct the interference at their own expense.
Refer to the Appendix for information on regulatory, compliance, and other safety requirements.