--- title: "Scenario 1: High-level steps for Virtual Sensor deployment" slug: "scenario-1-high-level-steps-for-virtual-sensor-deployment" tags: ["Product Usage", "vIPS 10.1.10"] updated: 2026-09-11T20:35:28Z published: 2026-09-11T20:35:28Z canonical: "docs.trellix.com/scenario-1-high-level-steps-for-virtual-sensor-deployment" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Scenario 1: High-level steps for Virtual Sensor deployment This section assumes the following for deploying the Virtual Sensor for scenario 1. - The ESX server meets the requirements as discussed in [Requirements for deploying the Virtual Sensor](/network-and-platform/docs/requirements-for-deploying-virtual-sensors). - You have the privileges on the ESX server to add and modify vSwitches and port groups. - You have installed the Virtual Sensor and established trust with the Manager successfully. As an example in this scenario, the management port is connected to vSwitch1. - As an example, this section uses the IPS-VM600 Virtual Sensor to explain the deployment. - This scenario involves only a Sensor monitoring port deployed in SPAN mode. - This section uses only the vSphere Client for configurations on the ESX. ## Task 1. Modify vSwitch0 to create a switch port group in promiscuous mode. Refer to the section [Modify an existing standard vSwitch for a monitoring port](/network-and-platform/docs/modify-an-existing-standard-vswitch-for-a-monitoring-port). Subsequently, you assign this switch port group to the SPAN port. 2. Modify vSwitch0 to create a switch port group. Subsequently, you assign this switch port group to the Sensor response port. 3. Configure the SPAN port on the Virtual Sensor in the Manager. 1. Click the **Devices** tab. 2. Select the domain from the **Domain** drop-down list. 3. In the left pane, click the **Devices** tab. 4. Select the device from the **Device** drop-down list. 5. Select **Setup** → **Physical Ports.** 6. Double-click on monitoring port 1 and then from the **Mode** drop-down, select **SPAN or Hub**. 7. Click **OK**. 8. Click **Save** in the **Monitoring Port Details** panel. 9. Select **Deploy Pending Changes** and, in the **Deploy Pending Changes** page, select **Configuration & Signature Set** for the required Virtual Sensor. Click **Update.** 4. Assign the switch port groups you created in steps 1 and 2 to the Sensor SPAN port and the response port respectively. See the section [Specify the switch port groups for monitoring ports](/network-and-platform/docs/specify-the-switch-port-groups-for-monitoring-ports). 5. Verify if you have deployed the Virtual Sensor correctly and whether it is inspecting traffic. Refer to the section [Verify the deployment](/network-and-platform/docs/verify-the-deployment).