--- title: "set autorecovery" slug: "set-autorecovery-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:52Z published: 2026-11-19T12:29:52Z canonical: "docs.trellix.com/set-autorecovery-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # set autorecovery This command disables auto recovery feature even if the Sensor has layer 2 mode is enabled. You can execute this command only if layer2 mode is **On**. When layer 2 mode is **Off**, auto-recovery is always disabled. You can disable the auto recovery feature for debugging purposes. By disabling the auto recovery feature, the Sensor does not perform auto recovery and remains in layer 2. > [!NOTE] > Note > > SSL Decryption are not supported if auto recovery is enabled. **Syntax:** `set autorecovery <enable|disable>` > [!NOTE] > Note > > If you disable auto recovery, it remains disabled even after disabling and enabling the layer 2 mode. To view the status of auto recovery you can execute the `show auto recovery status` command. **Default Value:** enable **Applicable to:** NS-Series Sensors > [!NOTE] > Note > > Auto-recovery is not applicable for Virtual IPS Sensors.