This command disables auto recovery feature even if the Sensor has layer 2 mode is enabled. You can execute this command only if layer2 mode is On. When layer 2 mode is Off, auto-recovery is always disabled.
You can disable the auto recovery feature for debugging purposes. By disabling the auto recovery feature, the Sensor does not perform auto recovery and remains in layer 2.
Note
SSL Decryption are not supported if auto recovery is enabled.
Syntax:
set autorecovery <enable|disable>
Note
If you disable auto recovery, it remains disabled even after disabling and enabling the layer 2 mode. To view the status of auto recovery you can execute the
show auto recovery statuscommand.
Default Value:
enable
Applicable to:
NS-Series Sensors
Note
Auto-recovery is not applicable for Virtual IPS Sensors.