--- title: "set fe-switch-hardware-hashing-method" slug: "set-fe-switch-hardware-hashing-method-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:27:25Z published: 2026-11-19T12:27:25Z canonical: "docs.trellix.com/set-fe-switch-hardware-hashing-method-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # set fe-switch-hardware-hashing-method This command is used to select the hashing method to distribute traffic through the Sensor. Note the following: - In a HA pair, when you execute the command on the primary Sensor, the command is set on the secondary Sensor also. - Sensor reboot does not change settings for the hashing method. **Syntax:** `set fe-switch-hardware-hashing-method <include_MPLS><exclude_MPLS>` | Parameter | Description | | --- | --- | | include_MPLS | When the incoming traffic to the Sensor is MPLS (Multiprotocol Label Switching) traffic, select this method. > [!NOTE] > Note > > This method will evenly distribute the MPLS traffic to the Sensor. | | exclude_MPLS | This is enabled by default when the incoming traffic to the Sensor is non-MPLS traffic. | **Sample output:** `IntruDbg#> set fe-switch-hardware-hashing-method include_MPLS` `include_MPLS : Rtag9 hashing algorithm to load balance traffic to trunk group(Id=10) is set` **Applicable to:** NS9300 Sensors only