---
title: "set fe-switch-hardware-hashing-method"
slug: "set-fe-switch-hardware-hashing-method"
tags: ["Product Usage", "IPS 10.1.10"]
updated: 2026-10-05T15:40:40Z
published: 2026-10-05T15:40:40Z
canonical: "docs.trellix.com/set-fe-switch-hardware-hashing-method"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# set fe-switch-hardware-hashing-method
This command is used to select the hashing method to distribute traffic through the Sensor.
Note the following:
- In a HA pair, when you execute the command on the primary Sensor, the command is set on the secondary Sensor also.
- Sensor reboot does not change settings for the hashing method.
**Syntax:**
set fe-switch-hardware-hashing-method <include_MPLS><exclude_MPLS>
| Parameter | Description |
| --- | --- |
| include_MPLS | When the incoming traffic to the Sensor is MPLS (Multiprotocol Label Switching) traffic, select this method. > [!NOTE] > Note > > This method will evenly distribute the MPLS traffic to the Sensor. |
| exclude_MPLS | This is enabled by default when the incoming traffic to the Sensor is non-MPLS traffic. |
**Sample output:**
IntruDbg#> set fe-switch-hardware-hashing-method include_MPLS
include_MPLS : Rtag9 hashing algorithm to load balance traffic to trunk group(Id=10) is set
**Applicable to:**
NS9300 Sensors only