This command helps configure the management port to match the speed of the network device connecting to the Sensor and to run in full-duplex or half-duplex mode.
Syntax:
set mgmtport <speed <10 | 100> duplex <full | half>>
| Parameter | Description |
|---|---|
| <10|100> | Sets the speed on the ethernet management port. The speed value can be either 10 or 100 Mbps. To set the speed to 1000 Mbps, use the set mgmtport auto command. |
| <half|full> | Sets the duplex setting on the ethernet management port. Set the value half for half-duplex and full for full-duplex. |
Note
The NS9500 and NS7500 Sensor models do not support this command. The speed of the management port in these Sensors is set to auto by default.
Default Value:
By default, the management port is set to auto (auto-negotiate).
Applicable to:
NS-series Sensors except NS9500 and NS7500