This command helps configure the management port to match the speed of the network device connecting to the Sensor and to run in full-duplex or half-duplex mode.
Syntax:
set mgmtport speed <10 | 100 | 1000 | 10000> duplex <half | full>
Parameter | Description |
|---|---|
<10 | 100 | 1000 | 10000> | Sets the speed on the ethernet management port. The speed value can be between 10 and 10000 Mbps depending on the Sensor model used. |
<half | full> | Sets the duplex setting on the ethernet management port. Set the value |
Note
The NS9600, NS9500, NS7600, and NS7500 Sensor models do not support this command. The speed of the management port in these Sensors is set to auto by default.
Default Value:
By default, the management port is set to auto (auto-negotiate).
Note
Management port speed settings vary depending on the Sensor model used.
Note
Availability of half duplex option depends on the management port speed you set. Duplex option is not available in 9100, 9200, and 9300 Sensors.
Applicable to:
NS-series Sensors (except NS9600, NS9500, NS7600, NS7500, and NS3600)