--- title: "Set the Fail-Open Bypass Switch parameters" slug: "set-the-fail-open-bypass-switch-parameters" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/set-the-fail-open-bypass-switch-parameters" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Set the Fail-Open Bypass Switch parameters You can access the command line interface through the console port (serial terminal emulator) and web-based management via a secure HTTPS connection on the management port (SSH remote shell emulator). **Steps:** 1. Ensure the power to the Bypass Switch is Off. 2. Using a DB-9 RS232 programming cable, connect a PC that is running the HyperTerminal to the Bypass Switch. 3. Launch the HyperTerminal and set the following communication parameters. - Bits per second: 115200 - Data bits: 8 - Parity: None - Stop: 1 - Flow Control: None 4. Click **OK**. The CLI banner and login prompt are displayed. > [!NOTE] > Note > > The default **Username** and **Password** are **McAfee**. The password is configurable. 5. Configure the following: 1. Set the DHCP static IP using the command, `set dhcp static`. 2. Set the Switch IP using the command, `set ip`. 3. Set the Gateway and the Mask using the commands, `set gw` and `set mask` respectively. 6. To view the Switch configurations use the `get` command.